Questions & Answers for: Pontiac Grand Am how to install a intake manifold

...intake manifold bolts. Remove the thermostat housing outlet and thermostat Clean the mating surfaces. To install: Install the thermostat and housing outlet. Install the thermostat housing bolts. ...

Ad

...intake manifold gasket leaks anti-freeze. I've put 2 new gaskets in it, the last one 15,000 klms ago. Now it leaks again. Is this a common problem on this car and is there a better fix than what I'm ...

Ad

...intake manifold on the drivers side of the engine compartment. You don't need to remove the exhaust. The best way to get to it is to remove the air cleaner and the duct attaching it to the throttle ...

...intake manifold bolts (two on each end) to 25 Nm (18 lb ft). rocker arms 14 N.m (124 lb. in.) plus 30 2.2L Engine & 2.4L Engines These engines are not equipped with rocker arms. The camshafts ...

Question about 2003 Grand Am

1 Answer

...intake manifold. Install the mounting bolt and nut. Tighten to 18 ft. lbs. (25 Nm). Install the air cleaner assembly. Connect the surge tank line to thermostat housing. Refill the cooling system. ...

...install the intake manifold brace and oil filter, if removed. Install the cooling fan assembly, then attach the electrical connector. If removed, install the air induction tube. Connect the negative ...

Question about 2000 Grand Am GT

2 Answers

...manifold torque instructions please help Head Bolts Torque sequence --------- ' 6 2 3 7 ' ' 5 1 4 8 ' --------- Step 1: torque in sequence to 33 Ft/Lbs Step 2: turn an additional 90 degrees recheck ...

Question about 1994 Grand Am

1 Answer

Install air intake assembly and top half of the air cleaner assembly. Install the brake vacuum pipe. Fill the cooling system. Connect the negative battery cable, then start the vehicle and verify that

intake manifold.         Install the mounting bolt and nut. Tighten to 18 ft. lbs. (25 Nm) for the 3.1L engine. For the 3.3L engine, tighten to 20 ft. lbs. (27 Nm).&

...intake manifold torque spec and pattern need torque procedure on rocker arm bolts and also on the intake manifold and what pattern to tighten them in 3.4 6 cylinder I could not answer this any better ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Manuals & User Guides

Loading...