Questions & Answers for: how to install a intake manifold

Ad

Question about 1999 Regal

1 Answer

install: Fig. Lower intake manifold bolt torque sequence-3.8L (VIN K) engine Clean all parts well with degreaser, especially the gasket seal surfaces on the upper and lower manifold pieces and between

Ad

...Install new gaskets and intake manifold on block while RTV is still wet to the touch. Use Threadlock 12345382 or equivalent to lower intake manifold bolts. Tighten lower intake manifold bolts in ...

Ad

...Intake manifold To install: Install or connect the following: Intake manifold with new gaskets. Torque the bolts, working from the center out, to 11 ft. lbs. (15 Nm). ECT sensor connector EGR tube to ...

Question about 1997 Grand Prix

2 Answers

...Install the intake manifold gaskets. Align the coolant bypass tube with the opening in the intake manifold and install the manifold. Tighten the bolts to 11 lb ft (15 Nm). Install the electrical ...

...Install the lower intake manifold. Tighten the bolts in sequence and in 3 steps, as follows: Step 1: 26 inch lbs. (3 Nm). Step 2: 106 inch lbs. (12 Nm). Step 3: 133 inch. lbs. (15 Nm). Install or ...

Question about 1996 Astro

1 Answer

...Install the upper intake manifold gasket. 2. Install the upper intake manifold. Use care not to pinch the injector lines between the upper and lower intake manifolds. 3. Install the upper intake ...

Question about 1996 Astro

1 Answer

...Install the intake manifold, fitting the plenum duct over the intake manifold duct. Loosely install the intake manifold bolts. Intake manifold torque sequence-4.6L engine Tighten the intake manifold ...

...intake. Install the solenoid valve mounting bracket and power steering support brace to the intake manifold. Connect the heater pipes to the intake and front cover. Attach the coolant bypass hose to ...

Question about 1993 Regal

1 Answer

Install the intake manifold gaskets with the port blocking plates facing the rear of the engine. Factory gaskets should have the words "This Side Up" visible. Apply gasket sealer to the front and rear

...Install upper intake manifold and hand start all attaching bolts.
5)Tighten bolts gradually starting in the center working outward until a torque of 12 Nm (105 inch lbs.) is obtained.
6)Install ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts

Marvin
Marvin

Level 3 Expert

85178 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

john h

Level 3 Expert

22402 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...