Questions & Answers for: Mercury install gear pinion

grinding noise from rear of 1999 Grand Marquis Car has about 80,000 miles and have noticed a "grinding" kind of noise from the rear of the car. This happens at low speeds when I am turning. It has ...

Ad

Replacing rear axle seal and bearing for 97 ford explorer Replacing wheel bearing and seal on rear axle and when removing pinion shaft pinion gears fell out. Not sure how to put them back, it seems a ...

Ad

...install steering gear mounting insulators into the steering gear housing. Push the steering gear mounting insulator and steering gear insulator in until there is no space between the lip on the ...

gear lube. On Ford products they use a synthetic additive in the rear and not in the front 4x4 axle. The next thing would be to determine if it is a wheel bearing or a pinion bearing. You have to pull

...pinion shaft. Install the differential pinion shaft. Install the differential pinion shaft lock bolt finger-tight. 12.CAUTION: Do not damage the inner wheel bearing oil seal (1177). Remove the two ...

gear shifter cable, also check transmission fluid level, if all that checks good, time for transmission overhaul. This sounds like a blown trany, check the fluid level first make sure its full, if its

...This job takes special pullers and presses, and needs to have the pinion reset, in relation to the ring gear. Failure to do so will cause noisy rearend. Take to a qualified shop for this

Question about 1996 Grand Marquis

1 Answer

and pinion gear is OK then it could be either the contact brushes or the armature contact area in the starter motor that have become worn. If brushes just replace them. If armature - replace the motor

Question about 1994 Tracer

1 Answer

...pinion gear worn, causing them to remain meshed 2) Starter axle shaft worn causing pinion to not retract 3) Electrical fault causing soledoid to remain engaged First, disconnect main lead on rear of ...

Question about 1994 Tracer

1 Answer

...for burn fluid or metal shavings. replace all seals and bearings. Torque pinion bearing to specs use new crush washer on pinion shaftDont forget friction modifier and recommend gear oil. Good

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

1999 Mercury Cougar
1999 Mercury Cougar

1,305 Questions

2001 Mercury Sable
2001 Mercury Sable

689 Questions

2000 Mercury Sable
2000 Mercury Sable

627 Questions

2002 Mercury Sable
2002 Mercury Sable

646 Questions

2000 Mercury Cougar
2000 Mercury Cougar

630 Questions

Top Mercury Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Mercury Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...