Questions & Answers for: Buick ignition switch wiring

Question about 1993 Skylark

1 Answer

ignition switch twice in the last 4 months. When I replaced the switch the first time, my a/c would not turn off when I turned the car off. This killed my battery and caused me to replace the ignition

Ad

...ignition switch, since absolutely nothing happened when I turned the key. Does anyone have any advice? It could be the ignition going out. To test the ignition you would have to get a volt meter and ...

Ad

ignition switch wiring diagram i need the ignition switch wiring diagram (red wire does what, pink wire does what...) for 1987 buick regal. thanks Thick wires at IGN SW .... Red(s) - supply power from

...ignition switch Hi iribosa. Here is the step-by-step instructions: 1. disconnect neg- battery cable, 2. then remove lower interior covers 7mm screws or 9/32. 3. locate cable for shift indictor remove ...

...ignition switch. a bad ignition switch will cause many starting problems. if switch is bad, then dash lights will not go off when turning key off. check wiring and starter first. have a good day

Question about 1989 Regal

1 Answer

ignition switch.locate the switch on the column and with the engine running wiggle the wires from the switch to its connedtor if it shuts down theproblem is in the hatnes where it connects If there is

Question about 1993 Roadmaster

0 Answer

ignition switch which is a high possibility but wanted to know if there is any other reason. There is a black wire that goes from the battery + terminal to the battery junction block (not the one that

Question about 1999 Regal

1 Answer

...ignition switch? Inspect/Test/Replace Hope this helps. An ignition switch supplies voltage to the ignition control module and/or the ignition coil. Often an ignition sytem thas two wires connected to ...

...switch what's s my problem Sounds as if wiring for the remote my have interrupted the ignition wiring. If it had been working and suddenly stopped, I would check for loose wire or bad ignition

...ignition switch ! Solder the resistor into the harness side wires , not going back to ignition switch . The wires break or contacts inside ignition switch do . You could check resistance with ohm ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

2000 Buick LeSabre
2000 Buick LeSabre

1,731 Questions

1997 Buick LeSabre
1997 Buick LeSabre

1,603 Questions

1995 Buick LeSabre
1995 Buick LeSabre

1,084 Questions

2002 Buick Rendezvous
2002 Buick Rendezvous

1,091 Questions

1994 Buick LeSabre
1994 Buick LeSabre

904 Questions

Top Buick Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Brad Brown

Level 3 Expert

19187 Answers

Are you a Buick Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...