Questions & Answers for: igniter is dirty

Need to locate the TCI Ignition on my 03 VMax. the bike back fires when you let off the throttle. Some say carbs are dirty and some say ignition box has water in it... I say carbs are dirty. ...

what causes delayed ignition, causing a slight boom on lighting main burner? There will be a web or bug or debris in the pllot asssembly /rail that blocks the path of the transition to main burner or ...

...Dirty flame rod 3. Bad igniter 4. Circuit board If the fuel pump makes a loud ticking or thumping sound, you have a fuel problem. The pump makes this sound because no fuel is getting to it. This can ...

My laars mighty therm keeps igniting on and over constanty, whats the problem There is a problem with flame rectification. This could be caused by a dirty flame sensor, poor ground to burner, faulty ...

my car wont start 1 Inspect Battery -- Battery Discharged or Faulty. 2 Inspect Battery Cable -- Corroded, Broken, Shorted or Poorly Connected Battery Cable. 3 Inspect Distributor Cap -- Distributor ...

problem with the ignition it will not turn on it does turn but will not turn on The pin on the back side of the key may be sheared or the "push" lever may not be moving. Lower your steering column to ...

...dirty igniter or clogged burner will prevent this from happening. First, try cleaning the igniter using a q-tip and some alcohol. If that doesn't work, clean out the burner holes. IMPORTANT: Let ...

why will my solo leaf blower not start ? Possible reasons for not starting.. No Fuel Spark plug dirty or worn out Ignition cable weak Ignition starter faulty Starter cable stuck part way Carburetor ...

...igniter and checked the fuses. Still doesn't light FL4 is related to the flow in your heater, you need to check first if you filters are too dirty, remove then reset breaker and try again if it go ...

...after 30 seconds ? Check for a faulty sensor. multi-reasons clogged filter --no fan-[hot air] igniter box failure --igniter rods dirty or fail- flame indicator sensor dirty/ fail --nozzle dirty ...