...motor won't idle, runs ok do these things have a idle control module? car has 95k An IAC (idle air control) motor is designed to adjust the engine idle RPM speed by opening and closing an air bypass ...
idle motor Engine won't idle. when it goes to idle motor shutters and stalls. will restart easily and runs ok just stalls when it idles. 1988 mighty max 4 cyl (2.4?)motor auto trans with 54,000 miles.
...idle air control motor in or out to adjust engine idle speed by controlling engine idle air. An idle air control motor can fail one of two ways, either the motor short circuits and stops working or ...
...idle air control motor in or out to adjust engine idle speed by controlling engine idle air. An idle air control motor can fail one of two ways, either the motor short circuits and stops working or ...
Question about 1989 Cherokee
...to fast. Idles at 1600 rpms in gear and 2000 rpms in park and idle. Have tried the idle stop and the throttle position sensor. What else can we try? Idle bypass screw adjustment or idle steper
Question about 1989 Cherokee
...idle air control motor in or out to adjust engine idle speed by controlling engine idle air. An idle air control motor can fail one of two ways, either the motor short circuits and stops working or ...
Question about 1999 DeVille
...idle motor usually pushes against the throttle plate to increase idle speed most idle motors (stepper motors) where phased out and was never used on port fuel injected engines chances are you have an ...
Question about 2003 Frontier Crew Cab
...idle motor going bad. The idle motor kicks down the idle as needed as the rpm dictates. If sudden reduction in rpm occurs the idle motor normally keeps up and motor continues running at reduced idle. ...
...is closed), is this air passage under the idle air control motor. The stepper motor allows it to control the amount of air, less for lower idle speed, more air for higher idle. See? Well, good
Question about 2003 Frontier Crew Cab
...Idle Air Control valve, driven by a small stepper motor. On that motor it is common for the IAC to become gummed up, so the motor can't move it correctly. It is a simple repair which any mechanic ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions