Questions & Answers for: Bosch transducer

...to far right facing them) would not reset. The light does not come on and I have no hot water. The transducer spins and there is no blockage in the inlet filter. The buttons in the thermal cut-outs ...

...flashes occassionally, not on steady. I checked the breakers and nothing is tripped. Also, the flow transducer is spinning and all wires look good and in place. Any suggestions? Thanks turn the temp ...

...and flow is good. Thermal Cut-outs are good - (not tripped) (Power at both sides or elements) Flow Transducer is spinning. No ohm reading at terminal end while spinning. Circuit board looks good -

how to change transducer Bosch parts are sold at Houseneeds: Each part comes with service bulletin and disclaimer advising you to have trained service technician install part to save money. http://www

...to touch and continues until reset on top pops is this a control panel problem or possibly a flow transducer any ideas THANKS I don't have specific suggestion for tankless tripping breaker or

...reading manual, to llook for reset switch, none to be found. also ran water and noticed the flow transducer is not spining . It moves when hot water comes on but stops immediatley If you smell it

...not tripped and reading 0.4 ohms. Resistance from probes on elements all well within range. Flow transducer spinning freely. Voltage good at terminal block. I'm thinking it is most likely

...238 volts between all phases. System does not kick on when you turn water on Control unit or flow transducer. If the transducer(impeller in the clear tube) is spinning freely with waterflow, then ...

...the neon will be off. other possible causes might be a crossover in your plumbing or a stuck flow transducer. Here is a link to a guide to explain how to check these items. ...