Questions & Answers for: Ford Bronco II hot water heater oil working

...hot. I removed thermostat and put in pan of water and brought temp up slowly, and it starts to open at 200- it should be 195, but I don't think 5 degress will make that big a difference. I did not ...

...water product.and it still wants to boil over. We rebuilt overdrive trans at same time.At this time I am running without thermostate installed.Seams as same problem exsists with differant motor,and ...

...water sometimes, have you changed the coolant or had to top-up? - Bleed the air out through bleed valve or loosen a hose while engine is running. Faulty heater valve. This can actually be the link to ...

...rate two qts. in bout five minutes oil perrsure then falls off but doesn't get hot Oil isnt going to keep it from getting hot. Find out where the oil is leaking from, and fix it, it may be too

...HOT REPLACED RADIATOR/WATER PUMP/FAN CLUTCH/HOSES.NO WATER IN OIL NO OIL IN WATER NO STEAM FROM EXAUST. The only item left that controls the flow of the coolant is the thermostat. It is and usually ...

...water. I would check to see that you are getting good circulation by checking the heater hoses near the firewall. If they are both getting hot then you may have an air baffle issue inside the heater ...

...temperature...Turn the heat on high...Does the upper radiator hose get hot and hard?...Feel the heater hoses...Does one, both, or neither hose get hot?... Send a ...

...heater hose going to water is cold, and my heater blows cold air, is my water pump going bad? the return heater hose is warm, it was heating once in awhile now it don't heat at all just cold air ...

hot. Be sure that radiator fan is working, too.   Other places to look for overheating: Make sure a/c condenser in front of radiator isn't clogged, and that the electric fan is coming on

...it gets hot and it will leak fluid this is my 3 train. Need to drill out the oil return hole in the pump. it's right there by the bushing. Just oversize it some it's not fussy. Go