Questions & Answers for: hood bent

...bent back toward the handle end at 15 degrees. Insert thru the grille, hook the rear of the hood lock, and pull the latch toward driver side until hood releases. Much easier said than done! ...

...bent it maybe?? Does anyone have any experience with the hood on 87 Jaguar that wont sit right? I have even replaced the springs attached to the hood and still it wont stay down on driver side in ...

...hood bent just enough where it wont latch? Try to put a 2x4 near the back part where the hinge or shock go and close hood gently andpush gently until hood bends back to shape and will close Hi! Have ...

...hood was bent but not to bad, the hood hindges, and mounting brackets were bent pretty bad will I have to get another hood or just the hindges ?? How do I adjust the hood so it is lined up with the ...

...bent. the hood is new (aftermarket) unfortunetly while driving down the road the hood flew up and damaged it. I don't want to have to buy another hood I just bought this one. help Replace All. Used ...

...if it releases,if it doesn't then cable may need replacing,I would'nt completely shut hood cause you may not get back open,also check hood latches bolts and latch for something bent or

...my other battery out and see itf it starts... also is it possible to get my hood bent back in to shape its not bent bad only like an inch if that..pls help tho battery is junk wreck shifted the ...

...new arm supports? or will the hood pins work? Check the support arms for damage, they could have slightly twisted or bent causing the hood pins from lining up properly. You may need new support

...hood latch was bent my mechanic tried to adjust it now hood won't open and my battery is dead Get someone to help you either push down on the hood while you pull the latch release or pull up on the ...

...bent the hood hinge on the front left keeping the hood from raising much. IF I can remove the fender MAYBE I can get to the hinge to work on it. It looks as though on this car there are fender ...