1988 chevy corvette headlight repair our 88 corvette pop up light would go up then back down so my husbund took it apart and he broke on of the tiny brushes he didn't realize he just needed to replace
...and the speedo works intermittently. No other problems on dash. u may need a speedometer signal generator if dash gage is on just not reading speed its located on the left rearend of tranny just ...
...THE ELECTRICAL BOOK DIDNT HAVE A DIAGRAM BUT IT TOLD WHAT AMP EACH COMPONENT USES AND VOLTS FROM GENERATOR. IF YOU HAVE A 55 CORVETTE YOU HAVE 6 VOLT ELECTRICAL SYSTEM.IF THIS DONT HELP YOU CAN GO ...
how to assemble an electeic motor/ getting the armature past the brushes The brushes are spring loaded (as you know), but if you look carefully, often there are small holes that a toothpick will fit ...
I have a 1960 chevrolet with a generator. I would like to convert to a one wire altenator. What is the wiring needed to connect this up. You need to replace original bulbs, sockets, fuse box, starter ...
...generator can be overhauled. The brushes, diodes, rectifier bridge and voltage regulator all can be replaced along with the stator, rotor and bearings although now days it may be cheaper to replace ...
1979 c-3 vette headlight fix Check fuses to make sure the resettable fuse has not failed. It is one of the small metal box like items in the fuse block. Also check the wiring to make sure ...
Question about 1979 Corvette
swapped out my alternator on my 77 corvette with a new one exactly the same and my generator light stays on could some one tell me if there is a voltage regulator on this model as it does not appear ...
car lopes as soon as it warms up top end redone lopes and no power top end falls on its face idle air control is looking for base idle. throttle body base idle plate is dirty with carbon. cleaned out ...
Question about 1991 Corvette
which way does does a horn brush fit on a 1960 corvette to make contact to the brass ring does the brass end or the copper end touches the brass ring on the column. Thanks one end should have a spade ...
Usually answered in minutes!
178 Questions
181 Questions
156 Questions
142 Questions
137 Questions