Questions & Answers for: kawasaki VN 800 A Vulcan front sprocket

front axle came out of my kvf 650 4x4,is it just like some type of o-ring that holds it in place or would i have to buy new shaft? Probably a snap-ring. Check with the dealer for one.

...front sprocket. An 18 tooth sprocket should help greatly. Alternate to that would be to get a smaller 38 tooth rear sprocket. The front sprocket will cost a lot less and is better for the chain than ...

front sprocket and 46 rear,at 70 mph the engine is wound up pretty tight,what to do Replace the front sprocket with a 15 tooth The stock ratio for these machines is a stupid 2.8:1. Change the front to

I have a '99 kawasaki vulcan 800, it has a rubbing sound near the back wheel and chain/sprocket area...could this be that the main bolt on back wheel is too tight. Tighting the bolt very tight is OK ...

front wheel torque specifications According to the Service Manual, the Front Axle Bolt should be torqued to 16 ft.lb for the pinch bolts 58 ft.lb for the front axle and in case you need it... 33 ft.lb

installing front wheel bearings and put front wheel back on bike and when tighten axle bolt wheel gets to tight to rotate sounds like you might have left out the center spacer,if not make sure you put

Tire pressuree for front and back, I lost manual If you are asking for tire pressure, use FR30-RR32 psi w/o passenger or put FR32-RR36psi if riding with pillion.

I need instruction for putting new seals and adding oil to front forks. forks are of many types, you should get a maintenace manual for your bike as it is a job only for the informed.

How do I replace fork seals and fork oil? I need step by step instructions. I have not worked on forks before, I have some mechanical experience, mostly automotive. I have replaced mono shock, ...

I have a 95 Kawasaki Vulcan 800. My chain loose in some spots and then it becomes tight with less then an inch of slack in it. How do I adjust this to make it right. this indicates the sprocket teeth ...