...vehicles the crankshaft sensor is mounted on the front of the transmission case adjacent to the flywheel. Please rate and god
...worn or damaged and does not turn easily by hand, remove it using a puller/slide hammer. Check the flywheel surface for scoring, cracks or burning and machine or replace, as necessary. Install a ...
I need flywheel torque specs for 2004 kia rio hi this is no problem it is 93nm, leave for 10 minuets then tighten to 103nm hope this helps please vote thanks
iam installing the torque converter to the flywheel. what direction does the motor turns? engine rotates clockwise
flywheel oil seal leaking leaking at the oil seal area.. This is called the rear main oil seal or the torque converter seal depending on what type of fluid is leaking out. To replace either seal you ...
Question about 2001 Rio
...You need a air impact gun like tire shops use..You can also remove the starter motor and jam the flywheel teeth with flat ended large
...is wrong with the starter and causing it not to push the gear from the starter into mesh with the flywheel. Also, sometimes it will start to turn over the engine, but before the engine is fully ...
...old. A clunk noise could be a couple of things. Your starter may be starting to go bad. If the flywheel or starter has broken a tooth on the gear, it will clunk. A loose starter, check the
Question about 2005 Rio
...pick a place where safe!!!...if it rolls forward while cranking ,the clutch plate is touching the flywheel (in other words the clutch all the way down while in gear while cranking,should NOT touch ...
Question about 2001 Rio
...has been sitting before i got the veh it sat for a year and a half the clutch plate rusted to the flywheel from the sound of it ,but the rest of the question is garbled to say the ...
Usually answered in minutes!
685 Questions
635 Questions
542 Questions
457 Questions
277 Questions