i need the torque settings for the clutch spring bolts on a gpz 1000rx A service manual is a valuable tool with an aging bike. I suggest the dealer/mfr. or Clymer books. In the meantime, go to the ...
I have a 87 gpz 1000r won't run. There is gas in the oil in the exhaust and coming out if the air filters. It takes a lot of trys to get it started also. When it is started it is really smoky and will
float height setting of my GPZ 1000 RX / ZX1000 A. from 1986? My dutch translated manual gives me 17mm, but since it doesn't get any fuel now at all, I don't trust this 17mm anymore.Thanks, Frank from
starts to turn over then load clunk and stops rock bike in gear and it will free motor and start Sounds like there is a tooth or several from the gears floating about somewhere in the engine/gearbox. ...
i need the specs for setting the floats and jets on a 1986 kawasaki gpz 1000 The float setting is 17mm frombase of carb to farthest edge of float ,holding carb vertical
Question about 1986 GPz 1000 RX
oil leak left side through rubber plug on side of valve train looks like a plug on the valve train You need a new set of cam plugs. they fill the half moon holes necessary for the cam bearing journals
Question about 1986 GPz 1000 RX
I have A 1988 Virago 1100 With Cobra Mufflers and The Carbs Are Jetted with A cobra I stage Kit And The Fuel Air Mix Screws are new It Cranks And Runs But Black Smoke Is Comming out of the Pipes Whats
...to the feul line sustem it flude the carborator before I start my bike Hey Chris, Could be a stuck float in one of the carb. bowls. ...
...cracked, or not attached, carburetor vent line plugged. 16. Needle and seat stuck closed in the float bowl. For more information about your issue and valuable "FREE" downloads that you need
...air leak. 11. Water, dirt, or rust in the fuel system. 12. Carburetor damaged, contaminated, sticky float, plugged jets. 13. Multiple carburetors out of sync. 14. Fuel filter clogged. 15. Old or ...
Usually answered in minutes!
43 Questions
18 Questions