Question about Tankless Hot Water Heater Rtg-74pvp-2 7.4 Gpm
flashing 12. I cleaned the filter, turned the remote off and back on again and I had hot water. What's going on with the water heater? in order to reset the unit you will have to turn the temp all the
Question about Tankless Hot Water Heater Rtg-74pvp-2 7.4 Gpm
...flashing code 2-3 1. Turn off power vent blower and set water heater temp to vacation (lowest temp) 2. Turn on power vent blower 3. Turn the water heater temp from vacation (lowest temp) to hot ...
Question about RTG-74PVN-2 Natural Gas Pronto Whole House, Natural Gas, Tankless Wat
temp on remote is set at 140 ? I just changed mine today with help from Rheem support as the manual had a typo error. You should be able to increse to 120 max as default. However if you want to change
Question about Paloma Tankless Water Heaters PTG-74PVN Tankless RTG-74PVN
No hot water this AM. I unplugged and reset the Paloma 7.4 NG unit, bled the gas line, tied in the remote (which I didn't use before), cleaned the water filter, and increased the temp to 110. The unit
Question about Paloma Tankless Water Heaters PTG-74PVN Tankless RTG-74PVN
I get a P1 error code on my rheem tankless water heater controler it flashes p1 & temp seting Unit worked fine for two days then this unit is new just installed it just clean shower head or faucet
Question about EcoSense by 7.4 GPM Tankless Water Heater Natural Gas High Altitude
flashing a code C7 and temp 76 and i have no hot water. what do i do? Before calling service technician, open following links for troubleshooting resources: http://waterheatertimer.org/pdf/Rheem-error
Question about Tankless Hot Water Heater Rtg-74pvp-2 7.4 Gpm
FLASHING "80" IF I HOLD TEMP UP BUTTON FLASHES "CL". FLASHING WILL NOT TURN OFF WITH ON/OFF BUTTON ON REMOTE I know this is late, but I just went through this problem right now, or
Question about Paloma PTG-74PVP / RTG-74PVP Liquid Propane Indoor
What does a C4/76 error code mean Runs for a few seconds to a few minutes then shuts off. Control panel flashes from C4 to 76, back and fourth. Reset it from the control panel, does it again. ...
Question about 50 Gallon FVR NATGAS Water Heater 6YR 22V50F1
Hi, i have a water heater (Rheem XG50T...) w/ a wifi module. Today, the temp / pressure relief valve drained a little bit and now my water heater does not work as the error A102 does not get clear eve
Question about 50 Gallon FVR NATGAS Water Heater 6YR 22V50F1
rheem hot water heater says set temp? no hot water If it is a gas water heater you must set the temp on the gas valve. Press the two outside buttons until they flash. Now you can use the arrow button ...
Usually answered in minutes!
335 Questions
250 Questions
267 Questions
222 Questions
190 Questions