Questions & Answers for: Samsung fix rubber sticky

Question about ML 1210 Laser Printer

2 Answers

...rubber cement (aka paper cement, it dries rubbery and sticky and usually comes with a brush in the cap of the jar). Rubber cement is old fashioned stuff you used to find in office stores but not so ...

Ad

...rubber cement on the pickup rollers to make the more sticky. That actually did help somewhat but now it isn't working again. Very frustrating printer. It worked great for about six months until it ...

Ad

Question about CLP 300 Laser Printer

3 Answers

sticky tape to hold them in place and don't obstrcut the "paper out" slot. Good luck! The rubber roll feeder gets dried out and won't grip the paper. Try replacing or conditioning it with armor all. I

Question about SCX 4200 All-In-One Laser Printer

2 Answers

fix; a small screwdriver or a bent piece of metal (and strong fingers) is all you need to do the repair. Remove roller from printer and Just rotate the rubber from plastic Hope this will work for u. .

Question about ML 2010 Laser Printer

2 Answers

...sticky" back to the rubber? Hello, you can remove and reverse roller to use it again. Unpin it from roght and left carefuly, clean it again whit alcohol, turn rubber a little bit and put it back into ...

Question about ML 1430 Laser Printer

1 Answer

...slowly remove the paper, while still holding the tab. Do this until all the sticky stuff comes off on the paper. This should fix the stickiness, and allow the tab to go back out. Thanks and take

Question about HP-R4252 42 in. Plasma HDTV

1 Answer

...rubber underneath the board that is sticky on both sides/ They sometimes use that I think to help prevent it shorting to the chassis. I have had some that were on pretty tight making you think it was ...

Question about PN50A650 49.96 in. Plasma HDTV

1 Answer

...the glass besides some sticky tape and a plastic frame! I will post what Samsung says after I receive the call from the technician on how to fix this problem. But this has fixed the problem for

Question about SyncMaster 243T (Black, Silver) Monitor

1 Answer

won't hold set position Short of mounting it to the wall, is there a way to fix the stand so it won't keep flopping forward after being set vertical? Easy way is double sticky tape on bottom of stand

...rubber hinge/strip problem) It is the bumper inside at the top which isn't gliding over the stop on the door side Try cleaning both surfaces with a bit of dish detergent on a damp sponge, to remove ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top Samsung Office Equipment and Supply Experts

Cindy Wells

Level 3 Expert

6688 Answers

Grand Canyon Tech
Grand Canyon Tech

Level 3 Expert

3867 Answers

Norman Weimar
Norman Weimar

Level 3 Expert

7035 Answers

Are you a Samsung Office Equipment and Supply Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...