...fault code up. The code is P0420, lambada/cat u/s. Took it for a big burn out and reset the codes, is it possible that the misfire just contaminated the sensor and when I took it for a burn out it ...
Fault code P1000 [18,2,10,0],Ford Fiesta 2005 Diagnnostic machine says 'Fault code P100 [18,2,10,0], Please refer to relevant technical manual ' anyone have any idea about this? Engine light goes on ...
Question about 2007 Focus (3 Door) Hatchback
fault code p0089 found on my car during diagnostic test, car also loosing power, Why? you managed to read a fault code?? well its the wrong fault code for a start because if this vehicle is a 2007 ...
...get your car plugged in to a fault code reader, they will attatch to your OBD plug and rear your fault codes from there. Once codes have been cleared and fault diagnosed the light will be ...
Fault Code (LFC) When the Restraints Control Module (RCM) detects a system fault, it will flash a coded sequence which is called a Lamp Fault Code (LFC) on the air bag warning indicator located in the
...fault code P1000 has no influence on the system <Engine management>, smooth running or performance as long as it is automatically erased whilst driving. The fault code P1000 indicates ...
Question about 2008 Focus 1.6
resetting fault codes the problem has returned. Car drives fine then o Electrical unless you physically repair the fault by replacing or fixing something then the fault code will reappear all the time
Question about 2008 Focus 1.6
...fault code Amy ideas what it is at all Hi there , good evening to you Ok the cluster self test is no good these are internal cluster codes and are not reliable or relavent You need to have a ...
Question about 2008 Focus 1.6
...fault code(s) you can start the diagnostics to repair the problem. This test is referred to as a OBD2 fault code test, any chain auto parts store like Autozone can do the fault code(s) test free. Ask ...
Question about 2008 Focus 1.6
fault code (LFC) 42, 43, 44, 45, 46 or 47 (or higher priority code if one exists) on the air bag indicator. Fault Conditions The RCM monitors for the following fault conditions: Low resistance Circuit
Usually answered in minutes!
3,749 Questions
2,998 Questions
2,612 Questions
2,348 Questions
2,636 Questions