1995 Chevy pickup but it's still blowing hot air. What else could be the problem? Do you hear any loud whinny sounds from your compressor? if so it may need replacing. You might also want to check the
Question about 1997 S-10 Pickup
...Fan switch for heater runs on high only. 1997 Chevy S10 pickup the fan switch for heater runs on high only. What is the problem and how can I fix it? replace the blower motor resistor located on the ...
fan worked the antilock brake wasn't on and the 4 wheel drive worked, so we think it is all connected. Any suggestions are greatly appreciated. Thanks OK, the anti-lock light is most likely one of the
...switch or blower motor resistors. check resistor pack for fan motor. fan is turned off compressor turns off. mastertech3's comments are possible. but so is resistor pack possible and easier to check. ...
Where is the Fan motor relay on a 1995 chevy astro van with air Cond The fan works but not on high speed. I have replaced fan switch check the blower resistor near the blower motor,
...1995 chevy s-10 pickup can't get brake lights to work. have you checked the fuse box and both brake light bulbs?check the microswitch on the brake pedal also. once the pedal moves downwards ...
...1995 s-10 chevy pickup no brake lights won't work Check your fuses, if all ok then the switch on your brake pedal is at fault, Look at the top of the brake pedal and you will see the location ...
Question about 1995 Chevy C/K Pickup 2500 AMI Billet Aluminum Interior Dash Knobs
what makes a 1995 chevy 2500 high idle and shifts hard High idel usually caused by vacuum leak, the high idle will make it shift hard as well.
Question about 1995 Chevy 1500 Pickup Truck Grill with Composite Headlights Gloss
...low beam light bulb on a 1995 chevy pickup truck? How to change the low beam head light bulb? the light bulb will be located at the back of the light houseing some low and high beams r in the same ...
Question about 1995 Chevy 2500 Pickup Truck Grill with Composite Headlights Gloss
...1995 chevy 2500 straight forward job. Remove the fan shroud, loosen the fan bolts before removing the fan belt, remove the fan, the hub, drain the coolant, remove the hoses, remove the water pump ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions