...exit sensor is jammed - either with a piece of paper, or the return spring on the sensor has stuck. Check this sensor, making sure it can return to the upright position freely. This should clear the ...
Question about Infoprint 1612 Laser Printer
exit sensor is bad. If you open the rear door, look inside where the paper starts to come out of the printer, you should see a small lever that triggers the PAPER EXIT sensor. It might be hard to see.
exit sensor (on the far right when looking into the rear of the machine) actuator does not return to "at rest" position quickly enough. There is a small spiral tension spring that returns the actuator
no paper evident(ie paper feeds cleanly, stops 1 inch past fuser) verify there are 2 sensor exit flags present and free to move. Occasionally 1 of the flags gets broken off the sensor causing this jam
Usually answered in minutes!
497 Questions
123 Questions
82 Questions
69 Questions
58 Questions