Error code 1 2 Had the blinking green light. Pressed Device and Menu and got the error code. Blinking green light stopped and then I pushed power. The TV is working. What is error 1 2? I found this ...
62 When I turned my tv on today I have sound but no picture. Did not get message that lams were bad. Can't figure out problem. If the lamp is bad, you will hear a buzz noise as it tries to fire up the
Question about WD-62725 62" Rear Projection HDTV-Ready Television
...TV with a solid red status light on the front. Used the Device and the menu buttons to get the 41 error code. Error codes seem to indicate a "short" of course that's not helpful at all. Where do I ...
Mitsubishi WD-62528 error code 45 tv will turn on but only stays on for about 5 min then wont turn back on for a few hours then only 5 min tried reset no luck pressed device + menu got four blinks ...
Question about WD-62525 62" Rear Projection HDTV
Where is the chassis fan location in a Mitsubishi wd 62525? I have a 35 error code on my television. I was wanting to check the fan. I know there are four fans. thats the fan thats directly mounted to
fault code 37 get a 37 fault code on 65 inch Mitsubishi dlp DMD fan error
Question about WD-62525 62" Rear Projection HDTV
getting error code 12 on mitsu wd 62525 dlp tv. any help would be great. 12 means no error detected. What are the symptoms of the set? If its the blinking led thats the DM caps which have failed.
mitsubishi tv error code 21 The service manual does not list an error code for "21". Here are the error codes: Error Code Probable Cause 12 No error detected 22 Recovery from momentary Reset 32 Lamp ...
Question about WD-62327 62" Rear Projection HDTV-Ready Television
I am getting error code 34 on my DLP TV. the bulb is new but i am still getting error code 34... my question is if i change the ballast (part number 939P978020) will this fix my error code and allow ...
replaced dlp chip. no getting error code 12. tv turns on, no picture, do have sound. fan on the dlp chip is no starting right away. Go back and make sure you do not have any loose or missing cables ...
Usually answered in minutes!
1,423 Questions
661 Questions
252 Questions
240 Questions
221 Questions