Questions & Answers for: Dodge Magnum engine wiring

...to take it to a shop unless yo have the tools and the time to take the covers off that are on the engine then follow the wires from the distributor to the spark plugs and do them one at a time. If ...

...sensor switch located and can I replace it myself? From what I can find, it's located under the engine. You can replace this yourself. There is a wire connector attached to it that you

...the spark plug of the dodge magnum 2006 · Open the hood and remove the bolts that hold the engine cover in place, if your Dodge comes with an engine cover (depending on model and year). If

location of engine cooling fan module on a dodge magnum 06 2.7 I HAVE ONE AND ITS THE FAN MOTORS THAT ARE BAD NOT THE MODULE TAKE A JUMPER WIRE AND CHECK THE FAN MOTOR FROM THE PLUG AT THE TOP ...

fans wont come on bobblevinsbu, You need to check the fuses first, especially the maxi fuses in the engine compartment. If these are good then try switching the fan relay with the horn relay. They are

...changed all my spark plugs and when I had finished I try to start my car and nothing and the check engine light is on. What to do? HI,Did you ensure you put the wires back correctly? What

...engine over heating due to cooling fans not running spin fans make sure there not seized check for power and ground to the fan connectors when the car is overheating if no power jump the ...

engine block. disconnect the wire and connect it to chasis ground. if the meter pegs then the sending unit is bad or you actually have low oil pressure. If the meter does nothing then you eithe have a

...the upper sensor. It is possible that the sensors are telling the electronic module to keep the engine from starting. However, you need to determine if you are getting fore to the spark plugs. If ...

...There is no solenoid fuse , the PCM - engine computer supply's the control voltage . You have a wiring problem ! http://www.obd-codes.com/p0404 Engine Code P0404 EGR Position Sensor ...