Questions & Answers for: Ford Focus engine thermostat

...engine. The thermostat is located in the housing connecting this hose to the engine head. Usually two bolts to come off. Remove old thermostat AND gasket. New part will come with gasket and ...

...engine. Install the thermostat, and a new gasket (or O -ring ), carefully replace the housing, being sure the thermostat doesn't slip out of position, tighten the housing bolts, reattach the radiator ...

radiator to the engine, it should connect to a metal fitting that bolts the the engine, have a drain pan ready underneath and remove those bolts, the thermostat should be underneath that metal fitting

thermostat Inoperative engine coolant temperature (ECT) sensor Inoperative Cylinder Head Temperature (CHT) sensor this usually points to a faulty thermostat. the engine is staying to cold for too long

...Thermostat Housing is off of the engine. Plastic can easily crack/score so be gentle whe removing the hoses and hardware. This housing is notorious for leaking even when a new gasket (O-Ring) is ...

...Follow the upper radiator hose from radiator to the engine where it connects to the engine thermostat will sit under that housing held on by two small bolt's.Hope this was very helpful,good

...engine there is the thermostat housing.Undo the bolts and lift off the connector and replace the thermostat.The thermostat housing is attached with three bolts.Lift the thermostat out of the housing. ...

...engine. The hose will be attached to the thermostat housing which is fastened to the engine with two bolts. While the engine is cold, remove these two bolts and lift up the housing to expose the ...

...engine is the thermostat located...top, bottom, or underneath like ive heard? The thermostat is located in the black housing that the top radiator hose runs to, on the driver side of engine. thanks ...

...thermostat housing or the engine block. Pretty sure it is in the cylinder head but it is controled by the ECM. Hope this answers your question. Make sure you do not have a air blockage after changing ...