Questions & Answers for: Poulan never ends

Throttle linkage for Poulan 1950le Which end goes to the carb, tried both ends still can't get it connected. It seems simple enough but can't get it hooked up. It came off while replacing gas lines. ...

Reattaching fuel line to gas tank. I have a weed eater trimmer model XT50. The fuel line rotted out. The fuel pickup filter inside the gas tank came out of it's hole. Is there an easy way to reseat ...

fix or unclog oiler on 16in. poulan chainsaw the end that goes into the resevuior comes out, the other end is a bloch with slats. Does that end pop out? in order to clean it? I believe it is clogged ...

Can,t find the spigot on which to reattach the clear plastic fuel line which got accidentally pulled off on my nearly new Poulin Woodshark saw. What end was pulled off.The end to the fuel tank goes ...

broken or worn shaft flex. Motor runs and head moves a little with no power. How to remove shaft from housing? First, about 4 Torx screws hold the end of the flex-drive tube to the engine housing. ...

pull cord came completly off I have a replacement but need step by step intruction in replacing cord on housing Remove the recoil assembly from the mower, there are 3 machine screws. Remove the old ...

Fuell pick up line is cracked and brittle. How do Fuell pick up line is cracked and brittle. How do I replace it? The fuel lins is normally just an interference fit in the fuel tank, so diss connect ...

How do I connect the fuel filter and tube to the fitting inside the fuel reservoir on a Poulon 2150 Chain Saw? The fuek hose is a push fit into the fuel tak, trim the end of the pipe to a point and ...

fuel line replacement poulan 2250 fuel line in tank has rotted out. Need to replace. also lines to purge valve. cut one end of the new hose down to 1/3 about a 1/2'' long slide a wire threw ...

how do i attach the bag to the vac i have the manual for the vac so i need a little help what part are you having a problem with? put large u shaped pip in the bag pull the small end out of the hole ...