Questions & Answers for: egr impala

...EGR VALVE IN MY 2000 IMPALA 3.4 REMOVAL PROCEDURE Turn OFF the ignition. Disconnect the EGR valve electrical connector. Remove the bolt retaining the pipe assembly from the EGR valve and carefully ...

...IMPALA 3.8 V6 egr valve locatio The egr valve is located at the end of a hose that plugs into youe valve cover. It is pushed right into a rubber grommet that is located in one of the valve covers. I ...

...EGR stuck open Chevy Impala 2001 w/ 3.8L engine - I changed out the EGR valve due to a code reading of "P1404". I cleared the computer then drove down the interstate for appx. 15 miles - 1 way. The ...

...impala i changed the egr valve and my check engine light is still coming on and a part store read my code and it said egr valve what else could be the problem The code in the ECU might not have reset ...

...impala, said its a egr I have a po 405 code on a 02 impala, said its a egr flow sensor , is this the mass air flow or the egr? I couldnt find a egr flow sensor on line? In Hopes the info BELOW will ...

...Impala, 3.4 engine. is EGR electric? cannot find vacuum line. egr (exhaust gas recirculator) is a flat, round disc with a metal tube that connects the exhaust manifold to the intake. good luck, hope ...

2204 chevy Impala 3.4 engine EGR VALVE LOCATED ON DRIVER SIDE ITS A AROUND LOOKING THING SITTING NEXT TO MASTER CYLINDER IT HAS A SMALL FLEXIBLE METAL PIPE THAT CONNECTS TO IT AND THE EXHAUST MANIFOLD

...impala 3.4 the EGR valve is located at the rear of the upper intake manifold, on the driver's side. It is electrically controlled and has a black plastic looking cylindrical cap with a wire connector ...

code p401 for chevy impala Code 401 is for a problem with the EGR valve air flow. It could be the EGR valve or the sensor.

...om my 2000 Chevy Impala Drive Cycle how to reset drive cycle on my car? Egr system Drive Cycle Issues What to Do When the Drive Cycle Won Complete OBD Monitor Not Ready General Motors Driving ...