Questions & Answers for: Isuzu Trooper drive pulley

Serpentine belt too tight to install I'm attempting to replace the serpentine belt on my 2000 Isuzu Trooper, and even after loosening the tensioner, it is way too tight to install. I've confirmed that

...drive pulley assembly. 7. Remove idle pulley assembly. 8. Remove serpentine belt tensioner assembly. 9. Remove power steering pump assembly. 10.Remove crankshaft pulley assembly using 5?8840?0133?0 ...

drive belt. it shreaded! Have replacement belt, and have it in correct positions. just cant get it on last pully wheel. I dont know which pully that loosens so I can get belt on and set tension. Can N

...pulley. Do not overtighten drive belt as this will pull on crankshaft pulley and cause a catastrofic imbalence and destroy crankshaft oil seal.I have learnt this at my cost.Do not continue driveing ...

drive belts. Remove the cooling fan assembly and the water pump pulley. Drain the fluid from the power steering reservoir. Unbolt and remove the power steering pump. Unbolt the hydraulic line brackets

...drive and the engine warms up the noise lessens to almost unnoticeable. the noise seems th be coming from the upper right front of the engine near the belt tensioner pulley. Visiual inspection does ...

...pulley on a 2001 isuzu trooper 3.5L,DOHC motor? 1=crank 2=alternator 3=idler tensioner 4=IDLER 5=fan idler 6=air cond compressor 7=accessory drive belt(serpentine belt) 8=power steering pump just in ...

...pulley, the timming mark on the pump drive gear (lower gear in this picture) will not line up but thats ok line up the mark on pulley to rear cover at about 12 O clock when the belt is off. i don`t ...

...drive belt size I used is 13/16" X 80-3/4" OC. The re-route consisted of routing the belt from the power steering pump to the fan pulley thereby bypassing the aircon. I had to do this since ...

...pulley. Loosen and remove the drive belts. Remove the upper timing belt covers. Remove the fan pulley assembly. Rotate the crankshaft to align the camshaft timing marks with the pointer dots on the ...