Questions & Answers for: Ford doesn t turn on

...Turn the switch for the 4x4 ,and the indicator light doesn`t show and the truck doesn`t go into 4x4. f150 2005 Hello David. The power for the switch is a 5 volt supply from the powertrain control ...

...doesn't apply. Turn your wheel fully to one side, and if it doesn't "grab" as you move, your 4wd is not functioning, and you need to take it to a mechanic, or grab a service manual, depending ...

doesn't turn on at all either (and the 4wd doesn't work either, but he said it was the 4wd engine thing that was not working?) do we need a whole new transmission? Also, the code that he's

...doesn't start or turn over at all. What may b it's problem. They have a bad ignition problem. Its more than likely the ignition. Turn the key on, Then right below the ignition theres a hole. ...

...doesn't turn on Your car has electric fans and they are activated by a switch that is mounted in the bottom of the radiator. What you need to do is verify first that the fan motor is good. After ...

...turn indicator but it doesn't seem to change anything Feel your heater hoses and see if they are getting hot..If so when your click from the switch ,,make sure the door is switching from hot to ...

...turn the A/C on? The fan always kicks on with the A/C, if it doesn't look for a blown fuse. Or possibly a fan motor burnt up. If it works with the A/C but doesn't when the engine is too warm, ...

...doesn't turn on ac system charged but compressor doesn't turn on Have you tried putting a wire jumper (paper clip works) in the compressor cycling switch in the low side of the ...

07 Fusion left turn signal doesn't work, no alarm on dash Bulb good Replace turn signal switch, this incurs professional knowledge with a long and tidious explaination.

...doesn't kick on...wont turn over...when turning to start lights stay on...ant theft blinks slowly when trying to start...tried jumping solenoid...starter turns but doesn't engage... get your ...