Questions & Answers for: Dodge Intrepid crank sensor

Question about 1994 Intrepid

2 Answers

...crank sensor no good why is there fuel pressure? check the asd relay swap it with another like it. also check fuses and old car alarm if it had one.the cam and crank sensor will not affect fuel ...

Ad

...crank sensor is bad on a 1994 dodge intrepid? Car has no spark unless it is put in a warm garage or the air temp is above 40 degrees. I took the crank sensor out and cleaned it off and put it back in ...

Ad

...sensor and crank sensors located on my car? I need a diagram showing where the cam sensor and crank sensors are located on a 1994 Dodge Intrepid 3.5l!? Crank Sensor: Passenger side of transmission ...

Question about 1999 Intrepid

1 Answer

...ignition switch, starter, cam sensor, or crank sensor? could be either the cam sensor or crank sensor , but I would check the crank sensor first , this sensor will not cause a check engine light ...

...crank sensor sends the signal to the coil, i would check it next CHECK THE CAM SENSOR AND CRANK SENSOR!! hi thies car are know for crank sensors if you have a volt meter unplug the crank sensor and ...

crank sensor is a common problem with that vehicle but I would be sure to check for bad wiring or lose connection from the crank sensor to the pcm also the. If no problem with the wiring and the crank

...start. It did it before and we changed the crank shaft sensor. It worked fine for a week and did it again. What else could be wrong?? crank sensor again or you ignition module( coil pack) or cam ...

...crank sensor is tied in with the tach,try start and look at your tach gauge for movement if it move up and down crank sensor it's ok if not you have problem with crank sensor or electrical

Question about 1996 Intrepid

1 Answer

...OF THE CAM SENSOR AND CRANK SENSOR ON MY 1999 DODGE INTREPID 2.7 LITER Cam sensor is right in front under the planum and crank sensor is by the crank harmonic balancer pully. But why do you

...sensor or crank sensor, the best thing to do would probably be to get it analyzed with an obd2 testor, that would pinpoint the problem to the correct sensor.... if that is not an option for you i ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Manuals & User Guides

Loading...