...cowl vent panel for access to wiper motor / remember the cowl has retainers that hold it in place but after you get the wipers off bolt for each one then can you lift up the cowl vent panels/ you ...
...cowl panel-to-firewall retaining clips Remove the driver's side then the passenger side cowl panel from the vehicle Fig.: Detach the electrical connector for the wiper motor Release the wiper motor ...
...panel to cowl brace retaining screw. Remove the instrument panel finish panel retaining screw. remove the retaining nut on the instrument LH lower finish panel. Remove the retaining brace. Disconnect ...
...cowl trim panel. Remove the bolt attaching the lower right end of the instrument panel to the side cowl. Remove the instrument panel pad as follows: Remove the 2 screws attaching the pad to the ...
cowl trim panel.On manual systems, disengage the temperature control cable housing from the bracket on top of the plenum. Disconnect the cable from the temperature blend door crank arm. On ATC systems
...panel to the cowl top and disconnect any remaining wires. Remove the instrument panel from the vehicle. If the instrument panel is being replaced, transfer all parts to the new panel. To install: ...
cowl trim panel. 8. Disengage temperature control cable housing from bracket on top of plenum. Disconnect cable from temperature blend door crank arm. 9. On models w/Automatic Temperature Control (ATC
Panel Cowl Brace 20 N606115-S100 Bolt (3 Req'd) A - Tighten to 9-14 Nm (80-123 Lb-In) B - Tighten to 10-14 Nm (89-123 Lb-In) C - Tighten to 2-3 Nm (18-26 Lb-In) D - Tighten to 47-63 Nm (35-46 Lb-Ft) E
panel cowl side nut from both sides Instrument panel cowl side bolt from the left side Instrument panel Windshield wiper mounting arm and the pivot shaft Electrical connector and remove the upper cowl
Usually answered in minutes!
661 Questions
611 Questions
534 Questions
488 Questions
496 Questions