Questions & Answers for: Euro-Pro cord replacement Irons

Ad

...cord replacement model 4750 I need to replace the power cord on my iron. Where are the screws to start taking it apart? Can you please provide direction for disassembly six screws on bottom plate two ...

Ad

Question about Shark GI475 Iron

2 Answers

broken electrical cord the insulation on the cord has cracked. how do i repair? if the wires aren't bare, wrap them in electrical tape. PLEASE RATE MY ANSWER. I agree. if the insulation is only ...

Ad

the cord has to be replaced . the model i have has a detachable iron. so all i need is a new cord with the connector. try hard ware store thumbs up

Question about Shark GI490 Iron

2 Answers

...green or green/yellow = earth. If in doubt, you should get a qualified electrician to replace the cord to your iron. Getting it wrong... can easily kill someone!!! regards robotek The wires from

...replacement cord/socket assembly. it should still be available, afterall it is a common problem. Just about any appliance repait place will do this for you , or yiu can order the assembly and do it ...

Question about Shark GI490 Iron

1 Answer

How to change the cord of the iron ? Remove the back plate where the cord attaches to the iron... there are 4 screws visible and another 2 screws hidden under the two rubber feet...These are joined ...

No power from cord. I want to replace the cord. In replacing the cord, you have to remove the screw that holds the back cover and unscrew the damaged cord from the heater terminal. Insert the new cord

fire came out of cord conecting to iron got a little burn on my arm The cord has an internal break and it made contact and burned through the insulation, your arm happened to be in the wrong place at ...

Question about Shark GI490 Iron

1 Answer

cord has a short in it You'll have to remedy or better replace the cord. Just buy similar to hardware store and put it to your iron. It's simple to replace and you have to have a analog tester

Question about Shark GI490 Iron

1 Answer

iron will not stay on More than likely your power cord has a broken wire. Plug the iron in and mover the cord around. See if you can find the broken wire. Typically where the cord comes out of the ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Manuals & User Guides

Loading...