Pull-cord will not retract. Brand new 18" poulan chuckless chainsaw. Used 2 times & pull-cord will not retract. I remove the cover, rewind the cord, re-attach cover & pull to start. Over & over. ...
...Poulin chain saw? First of all the fan housing needs to be removed. No need to remove handle from cord. Just undo screws from fan housing and remove the whole assembly. Inside you will see the ...
Question about Poulan/Weed Eater No. Bvm200le 711482 24cc Gas Blower/Vac
need to thread the cord on a poulon 031pro Remove the side coverto get to reel Remove any broken cord. Turn reecounter clockwise till it nestops then slowly let turn back till the hole li nes up then ...
the rope does not retract when the cord is pulle... how do I fix it Has the cord been replaced? If so, when the old one broke, the spring will completely unwind. The trick is to rewind the spring ...
Question about Pro 22inch 625 Series Briggs Stratton Gas Powered Side DischargeMulch Front Wheel Drive SelfPropelled Lawn Mower (CA Compliant) PR625Y22RPX
pull cord is stuck My lawn mower cut off due to no gas, i filled it up, now the pull cord is stuck. i am at a loss...... Take off your cover to the pull cord, the cord probably just got wrapped around
Question about P3416 16Inch 34cc 2Cycle Gas Powered Chain Saw
...or four turns more without becoming 'bound' which would lock the spool and not permit return of the cord. When the spring is wound, wedge it so that the cord can be attached, the work the cord around ...
Question about Pro 42CC 2 Cycle Chainsaw, 18"
How does the spring attach to the pull cord after you get it wound back up? The outer spring should attach to the cord spool in a recess or post. Wedge it to keep it from unwinding, attach the inner ...
My pull start cord won't retract. How do I fix it Remove the starter assembly from the engine and pull the cord out--it should have spring resistance to pulling. If nothing, the rewind spring may be ...
...is only coming out about 8 inches. It's stuck...what should I do? Remove the starter and pull the cord, if the cord still only comes out so far it is either the cord is too short ( replace the cord
...start? Remove the four screws securing the starter houseing, with the starter removed, pull the cord out, tuck the cord into the cut a way in the side of the pulley and allow the cord to wind in ...
Usually answered in minutes!
583 Questions
457 Questions
255 Questions