Questions & Answers for: cleaning throttle body sensor gmc

...throttle body. I hope this info will help. The MAP is located right nest to the throttle body  right around where the throttle cables hook up to the throttle body. You will have to pull the air ...

...throttle body. Which is in the front of the intake manifold. You have to replace the whole throttle body on the 2003 Yukon - the sensor is combined with the body. it cost me $160 for a whole new ...

...350 and throttle body it runs like it is stuck on choke i have replaced o2 sensor,throttle position sensor,fuel temp.sensor and removed thottle body and cleaned but still does the same. check ...

...throttle body it acts like it is stuck on choke i have replaced throttle position sensor,o2 sensor,temp. sensor,egr valve snd removed throttle body and cleaned . i have unpluged each of the injectors ...

...throttle body while you were in there? If not, that's your problem. When you hooked the battery back up, the computer thought the throttle body was functioning properly. Learned some bad habits ...

...throttle body. Also, disconnect the battery during the cleaning process to allow the computer to reset and relearn to the cleaned throttle body.And, do not use any of those "gas saving" chips, they ...

throttle body how do i clean the maf sensor and throttle body Autozone, carquest ect. sell MAF sensor cleaner. Do not touch the sensor because it will most likely break. Pull the throttle body off and

...throttle body. My 2004 is doing this too. You can try cleaning or replace it. Also, disconnect the battery for about 24 hrs and it may reset. If its made in the throttle body, like mine, you have to ...

...throttle body. Unhook the electrical connector on top of throttle body, then remove the 4 bolts that hold it in. Use a product like Seafoam spray (or sensor safe spray) to clean with rag or nylon ...

...GMC envoy Try cleaning the throttle body, filters, and sensors. Clean or replace the idle air control valve. Chances are this will improve idle RPM. You dont ecm sets it try cleaning your throttle ...