...rear three wires and plugs. I am under the impression that only the top of the intake manifold plenum needs to be removed to reach the back three plugs. Is this correct? Also, car is misfiring-how do ...
PO401 I had the same problem at 78K miles and replaced all EGR related items, plugs, and wires but problem persisted. Ended up being an ignition coil problem. Replaced the ignition coil, not small ...
ignition on any spark plug coil? I appreciate any input you guys might have. Thanks! the air fuel control mod can cause the prob you are having 1990 to 2000 ford rangers are bad about doing what yours
...2000 Mercury Sable. runs at speed and under load but idle is rough and stalls frequently while at the lights or just sitting for a short time in drive or park. I changed the plugs, the air and fuel ...
how to change the ignition coil in a mercury sable There are six "individual coils". One over each of the spark plugs.
it shows cylinder 4 misfire ,,i changed spark plug and ignition coil but still same problem ,,engine shakes while driving but after 60mph its smooth........ a misfire can either be fuel, spark or ...
cylinder # 2 is misfiring. If it is a coil on plug ignition, it could be a bad coil. Could be a bad plug could be a bad plug wire could be alll the above
wont start in cold Hi, Please check comprehensively your ignition. A bad ignition will working worst while the engine in cold. Your coil should has blue ray while it work ( for best). Also check your ...
Question about 2000 Sable
...2000 sable turns over but wont start engine light on but pulls no codes i have a 2000 mercury sable wont start. its getting gas, but not getting fire. i change the crank sensor an the coil pack but ...
intermittent starting problem Check the ignition coil where it snaps onto the top of the ignition coil. They like to corrode on the coil terminal and cause this condition.
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions