the oil pan. tale it to an auto shop and have them re tap(put new threads) in the oil pan and this will fix the problem. hope this helps. You need a washer on the drain plug. This will create the seal
...Hi and welcome to FixYa, Initially, if the "tapping sound" was not present before the plugs were changed, then one can suspect that the new plug might be the cause: missing crush washer making the ...
...change coolant WITH COOL ENGINE Locate water pump cover on engine, place container underneath then remove drain bolt (the 1 with the copper sealing washer). Only a drip will come out until you undo ...
change the rear wheel bearings The rear hub and bearing are combined into a single assembly. The bearing is sealed for life and requires no lubrication or attention. If the bearing is worn or damaged,
...washer used and i changed the motor oil and ran it maybe 5 minutes. later i checked the oil level again and it shot out the cap and i noticed the pump oil level is also almost to the top of sight ...
...tap the drain hole in the crankcase out to the next size bolt. That is the best fix for a stripped drain bolt hole. Always be careful, when changing your oil , to only tight the filter and the drain ...
Question about 2500 PSI Gas Pressure Washer
...Honda GCV 190 gas pressure washer. It starts up okay and runs for 20-45 seconds and then stops. We have changed bot the gasoline and the oil but run into the same problem. check that the fuel tap is ...
Question about 1999 GL 1500 SE Gold Wing
change the differential fluid on a GL1500SE HI , ON THIS MODEL YOU HAVE A DRAIN PLUG AT THE BOTTOM, THIS WILL BE A 12 OR 14mm BOLT HEAD, REMOVE THIS BOLT AND THE OIL WILL DRAIN OUT. ON THE SIDE OF THE
...change the crankshaft seal on a 1993 Honda Accord LX? jack car up set on stands ,remove passenger side wheel,remove plastic cover on fender ,i believe is a 36mm socket to loosen nut on harmonica ...
Question about GX690 Horizontal Shaft Engine Snorkle AF 1-1/8 x 3-1/2 GX690-TXF2
engine runs fine until you add a load and then it sputters and putts and loses rpm. I've changed fuel pump and filter; problem still exists. carburetor dirt inside, press helpful button and check link
Usually answered in minutes!
2,998 Questions
2,681 Questions
1,631 Questions
1,636 Questions
1,570 Questions