Questions & Answers for: Oldsmobile Cutlass Supreme camshaft sensor

...camshaft position sensor located? I have a 93 Cutlass Supreme, I've replaced the fuel filter, fuel pump, and crankshaft sensor. It will not start. It ran briefly, but died and will not start again. A ...

camshaft sensor located where the serpentine belt passes over the crankshaft pulley. Remove the belt and the harmonic balancer--the sensor is located just behind the balancer. It requires an alignment

...camshaft position sensor located on a 1996 Oldsmobile cutlass supreme the sensor is located behind the power steering pump the plug is on the front left side of motor red and green wires trace it to ...

...like it is out of time then be normal has good compresion across board scanner says timing is right on I would check the crankshaft, camshaft sensor and the control module. Also check the plug

...camshaft sensor, lubricate the new O-ring with clean engine oil. Tighten the bolt to 88 inch lbs. (10 Nm). Do not over-tighten. Connect the negative battery cable. 3.8L Engine To Remove: Disconnect ...

...camshaft sensor do? is it worth it to get it replaced? my check engine soon light has been on because of it for the past 2 years and its irritating to look at. A magnetic or hall effect sensor. It ...

where is the camshaft position sensor located If you have a 3.1l it is under the powersteering pump, take a flashlight and look under it you can see it has a 10 mm bolt holding it in.

camshaft sensor where is it? On most vehicles its inside the disturbuter cap under the rotor a couple of screws hold it in

...camshaft sensor, is your security light staying on? If so, it could be your security system, passlock was installed in many gm's and caused alot of problems. Have your starter checked at autozone ...

...any RPM when I crank it over. So...where do I go from here? The PCM bases injector pulse timing and sequence on the camshaft position sensor. If that sensor and circuit is good, it could be a bad