Questions & Answers for: Ford camshaft

Question about 2000 Escort

2000 escort zx2 part name and how to remove it

...Honestly iam at a loss never seen this on a europeon model. I think i found the part name: Variable Camshaft Timing Oil Control Solenoid ?2.0L Zetec Removal Remove the camshafts, refer to Section ...

Question about 1993 Taurus

1 Answer

1993 ford taurus,

...What is left to do ? At this time I am running out of cash and ideals.Can anyone help? The camshaft position sensor sends a signal to the PCM, powertrain control module. The PCM then ...

Question about 1999 Escort

1 Answer

I need the timing marks for a 1999 ford escort ZX2

...cylinder block (6010). Position the crankshaft (6303) just prior to top dead center. Install the Camshaft Alignment Timing Tool on the back of the camshafts. NOTE: Make sure the correct (second) ...

Question about 2001 Taurus

2 Answers

Engine light on with code P1309

engine light on with code P1309 This code could mean: the camshaft position sensor could be defective, the camshaft synchronizer (the part that took the place of the distributor on DIS engines) has ...

Question about 1999 Taurus

1 Answer

Where is the location of camshaft sensor, vehicle

where is the location of camshaft sensor, vehicle will not start The camshaft position sensor (CMP) on the 3.0L OHC (4 valve) and 3.4L SHO engines is a variable reluctance sensor that is triggered by ...

Question about 2004 Escape

1 Answer

Image of a timing belt

...a timing belt diagram 2004 ford escape four wheel drive Please rate, thx. Installation CAUTION: The camshaft must be held stationary at the hexagons with locking pliers. Do not use the alignment tool ...

Question about 1985 F150

1 Answer

On a 1985 f150 where would a camshaft sensor be

On a 1985 f150 where would a camshaft sensor be Check this procedure... REMOVALand& INSTALLATION6-300 Remove the grille, radiator, and timing cover. Remove the distributor, fuel pump, oil pan and ...

Question about 2006 Taurus

1 Answer

I changed out the MAP sensor,and the idle air sensor on my 2006 Ford Taurus. This was before I had the fault code read at a dealer. Code came back as P0340, and P0430 Band 2 cat worn out. I had the ca

...or is catalatic converter bad. The car has tehe 3.0 vulcan and 139,000 miles on it P0340 FORD - Camshaft Position Sensor Circuit Bank 1 Sensor 1Possible causes- Faulty Camshaft Position Sensor - ...

Question about 2003 Focus

2 Answers

Where is 2003 ford focus camshafts position sensor

where is 2003 ford focus camshafts position sensor location of camshaft position sensor Camshaft Position Sensor The camshaft position (CMP) sensor detects the position of the camshaft. The CMP sensor

Question about 2003 Focus

1 Answer

Ford fiesta 1.6 duratec no oil on exhaust camshaft

Ford fiesta 1.6 duratec no oil on exhaust camshaft Oil on intake camshaft but dry on exhaust camshaft so not sure if oil gallery on exhaust side of camshaft is blocked or what.Any ideas? Probably a ...