Questions & Answers for: cam belts

belts 95 nissan pathfinder serpentine belt diagram Timing belt has marks on it that refer to the cam marks and the crank gear. Looking at the engine from the front, the timing belt should drape over ...

...new timing belt slowly disapearing!!! the timing belt keeps walking towards the outside of the cam gears its slowly disapearing , soon there will be no belt. the belt that came off was fine?? ...

Noisy engine suggesting cam belt prob at 50,000 miles My 2006 Elantra engine is a bit noisy - could the cam belt need replacing after 80,000kms? Do you mean the "Timing Belt"? There is NO Cam belt.. ...

cam belts just wanted to know if the ford focus 1.8 tdci has cam belts or chain as our 2004 focus is at the mileage where a cam belt would need to be changed. timing belts should be replace at 60,000 ...

...to sincronize the timing belt of my isuzu tropper 3.2 sohc if this is 6VD1 engine it has single cam gear each head, but is still a 2 cams per head, engine if belt has broke or you have turned any ...

how do i replace the camshaft sensor on a 1999 daewoo nubira? do i have to take the timing belt off? no dont need to take belt off if its twin cam by the sound of things just top bolt which is inside ...

where is cam belt situated on daihatsu sirion. Is it adjacent to the fan belt?. Would the cam belt affect the power steering? THERE IS NO CAM BELT , THE TIMING BELT IS TURNED BY THE CAMSHAFT , THE ...

just done a timing belt on my 1997 eclipse and the cams are still off their timing marks what can i do ? reset belt on cam till you have it on IF THERE ARE NO CAM THRUST BEARING PROBLEMS THEN YOU NEED

camry timing belt Both the 2.2 Liter 4 cylinder and the 3.0 Liter V6 have a cam belt that must be replaced every 60,000 miles. The cam belt also drives the water pump and for this reason I recommend ...

...daewoo lanos?? Would there be any head damage? yes it is quite possible that valves are bent if the cam belt broke or teeth stripped off of old belt, which unfortuneately means removing the cylinder ...