...Faulty alternator/generator and or voltage regulator. 3. Loose or corroded battery terminals and or cables especially the "NEGATIVE" cable, look for loose, corroded, or broken connectors inside the ...
moped throttle sticking Most likely to be the throttle cable sticking. Try lubricating or replace Ride Safe Bike-doc Please mark this as useful (if it has been!!)
2001 yamaha blaster clutch doesnt disengage and clutch cable is good and moves at the housing Remove clutch cover and check to see if clutch is actually disengaging. Either it is not hooked up ...
my rear brake on my tw sticks on, when used, therefore cant use it at the mo, ive no technical knowledge so is there an easy way to sort this? Yeah, here's what to check: If the problem isn't a simple
Question about 2002 TW 125
locate a wiring diagram for your bike. Typically, there is battery voltage to only one of the large cables attached to the solenoid. The 'hot' one comes directly from the positive side of the battery,
...to me to download? thanks. glen. Hi glen Replacing the disk is quite easy. Remove odometer cable, Disassembly front wheel, then screw out 6 bolts of disk. Replace disk+ fix it with bolts. ...
...in the "OFF" position. 3. Check the battery terminals for damage or corrosion check the battery cables at "BOTH" ends for loose, corroded, or broken connectors, "INSIDE" and outside the cable ...
cable that is stuck. Try loosening the throttle cable on the handelbar adjustment. Your cable might be too tight & lubricate the cable. If that don't help, the slide in the carb is stuck open,
...the paddle switch on the side of the carb, make sure its not turning on once you ride it, if its a cable check its retracting fully by lubing the cable.and also Fuel treatment e.g. redex isnt a ...
Usually answered in minutes!
21 Questions
16 Questions
10 Questions
14 Questions