1999 Toyota Camry V-6. No Start. Checked coil packs, enstalled new plugs. Checked timing, mass air flow, cam sensor and crank sensor, fuel injectors, ignitor. everything seems to work but will not ...
oil leaking from rear main seal, how hard is this to change. And whats the going rate for a shop to do the repair. Replacing the rear main seal is kind of a long one. It involves seperating the motor ...
Question about 1989 Celica Liftback
...If the fitting is straight on and is clean on the inside before you seated the hose, there may be a burr of the pump side where the fitting sits. Some of these fittings are replaceable and others ...
Model 2200 EC1 SERIES The top thread Bunches and tangles on the underside of the sewn material. I have checked that the upper thread tensioner is in good order. When I observe the thread in the ...
...the machine check the tension to see if it's correct check the needles closely to see if there's a burr on the needle eye check the throat plate for burrs check the loopers for ...
sticky carburator choke check for burrs then spray wd40 on it and work it back and forth/or check the spring
Question about SE-06 Mechanical Sewing Machine
...the top thread is getting stuck on something in the bobbin case. sometimes the needle plate gets a burr on it which will break the thread when sewing. Usually 2 screws hold the needle plate on and ...
I have a Toyota RS2000 sewing machine. The thread has suddenly started breaking, and I am getting big bundles of thread under the fabric. What is wrong please? try a top thread tension of 4 change to ...
Question about SE-06 Mechanical Sewing Machine
...will cause a belt to shred on a 2006 Toyota Tundra 4.7 pulley bearings or pulleys not in line or burr on pulleys Check the harmonic balancer to see if it is coming apart and moving forward causing ...
Question about SE-06 Mechanical Sewing Machine
...are the original items that you had dismantled earlier? You have presumably checked both items for burr damage and you will have checked if there is a master spline or similar and ensured alignment ...
Usually answered in minutes!
1,828 Questions
1,753 Questions
1,565 Questions
1,303 Questions
1,231 Questions