Questions & Answers for: broken valves

Question about 1999 300M

1 Answer

BENT OR BROKEN VALVE HOW DO I REPLACE BENT OR BROKEN VALVE If you are referring to an intake or exhaust valve, cylinder head must be removed (and likely replaced if valve is broken) Also if that's the

Ad

...broken timing belt, will it cause valves problem. Thx I had the same thing happen, No, I was told this is not one of the engines that allows the piston to contact the valves. I replaced the timing ...

Ad

...valves. Noisy engine. Excessive valve chatter1. Valve clearance too large.2. Weakened or broken valve springs.3. Worn down camshaft.Noise appears to come from piston1. Piston or cylinder worn down.2. ...

...valves & pistons Broken Timing belt on peugeot 106 1100 cc will valves be damaged i presume its a tu engine!? these are very good engines and have been known to survive a broken cam belt. i would ...

Question about 1991 405

3 Answers

...broken ),,, or piston rings are totally worn out,, could also be a bad valve spring. start by removing the valve cover and inspect the valves on cylinder #1. if valves look intact then the next step ...

my engine rattles when starting idles funny and shakes you may have a broken or stuck valve that may have also broken a rocker arm.the valve cover will have to be pulled to inspect the valve train ...

honda gc160 steps to change a broken valve i picked up a generator with a honda 5hp engine. no compression so i took off valve cover. one valve had the end broken off and the spring came off. i have ...

broken because there was not enough downward movement in the valves to allow the cam to complete its turn. IT happens when the valve spring retainer either hits the top of the valve guide or the valve

...valves A broken timing belt will allow the valves to hit the tops of the pistons if your vehicle is equipped with an "interference" cylinder head. A "non-interference" head will allow the valve train ...

Question about 1996 SW

1 Answer

...dirt 3 floss with o-rings valves 1 valve has dirt or broken o-ring between 1 of the valves 4 pressure control valve was not screwed. the nozzle (if it is a dirtkiller) is is broken mostly

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...