Questions & Answers for: Plymouth brake cleaner

...brake cleaner you can buy bothe from pepboys or canadian tire depending where you live or 2 the window rubber is out of the frame and binding on the window ( fix it soon or it will be expensive as ...

Ad

...brake. Is there a ''hard stop idle adjust'' screw? If so, do you have a diagram so I can find it? Remove your AIS (automatic idle speed motor) on side of throttle body, and spray it well ,especially ...

Ad

...have a fuel issue. If someones sprays a little brake cleaner in the Throttle body and it starts then you have a pump issue. If it still doeant fire up then you know for sure you have a spark

...Brake Cleaner 2. Brake Lubricant Steps: Step 1 Secure your vehicle on a level surface, making sure your car will not roll or lean too much when jacked up. o Tip: Safety Tip:Always wear safety glasses ...

Question about 1999 Grand Voyager

1 Answer

...brake cleaner, a large C-clamp, new pads (front) and I'd replace the front rotors too. Place the van on jack stands, remove front tires, using some brake cleaner spray down the calipers, pay special ...

Question about 1999 Grand Voyager

1 Answer

Sounds like a leaking intake gasket. while its running, spray brake cleaner where the intake bolts to the block. If it idles up while spraying its either the intake gasket or a vaccum line. Good Luck

Question about 1996 Neon

1 Answer

...cleaner or brake cleaner. Make sure you are careful not to damage the MAF sensor, and make sure it's dry before reinstallingInspect all vacuum and PCV hoses, replace if necessaryCheck for a dirty ...

...brake booster. The timing is set at 10 degrees with the coolant temp sensor unplugged. I know this is how you set it on fuel injection but not sure on carbureted. The carburetor was set following the ...

...of the calipers. You might try cleaning and greasing the glide pins. Check tightness and clean rotors well with brake cleaner Spray springs and shock absorbers with WD40 make sure it goes everywhere

...brake pedal. (you don't have to KILL it) When they say "K!", you open the bleeder. Note the passage of air bubbles and fluid into the tube. After about 4 seconds, close the bleeder and repeat. The ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top Plymouth Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Brad Brown

Level 3 Expert

19187 Answers

Are you a Plymouth Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...