...mu 1993 brakes still spongy after being bled have changed brakes, have bled the system but brakes still spongy, what causes this how can i fix the problem hello the master cylinder may be bad ...
to move. i have to release brakes and apply again to be able to stop> your master cylinder is gone. when stopped apply pedal and hold let up slightly then reapply if pedal sinks to floor master is bad
brakes my brakes was bad i need to 2 pumps before it will stop IF THE BRAKE FLUID IN THE MASTER CYLINDER IS FULL U HAVE A BAD BRAKE MASTER CYLINDER
brakes rear tail lights come back on. Most likely a bad earth to the light's. Re-earth the tail lights should sort the problem. What most likely you have on the rear lights is a bad ground between the
...no my car Sounds like you have a bad brake cylinder or line on one of your brakes. Check for leaking brake fluid on the inside of all tires. If wet, pull tire and check whre the fluid is leaking
Brakes work fine. what can I do to turn it off? Maybe it is the sensor for your park brake lever-it thinks your park brake is on. These can go bad also-check and see if yours looks faulty-if its cheap
...rotor is still considerably hotter than the 3 others. Your brake caliper on this tire is likely bad, but it could also be a problem with the emergency brake cable hanging up on this wheel. Were ...
...brakes how bad do they squeak, is this after a recent brake job? minor squeak is normal and doesn't affect the performance of the brakes, u can apply a product call "brake quiet" to the back of the ...
...pulling to one side bad brakes. do not drive with bad brakes. tires low on one side? or wrong sizes mixed.! bad suspension alignment. Seized wheel bearing pulling all the time or only
...bad or its wires or pins rusty. brakes: the brake lamp has 3 inputs ("OR" logic) master cylinder level low. the hand brake lever and the EBCM (electronic brake control module) a technician unplugs ...
Usually answered in minutes!
832 Questions
814 Questions
819 Questions
720 Questions
623 Questions