Questions & Answers for: Delphi bad antenna

...or the antenna is going bad. if there is no obstructions on the car blocking the antenna i would advise purchasing a new antenna. you can get one at

...the antenna. If it is saying no signal then check the connection at the unit where the antenna plugs into. If thats good then it either could be a bad antenna or a bad dock where your unit sits

...antenna help me out here what is going on The Tuner is bad. It's a very very very common problem among Sirius and XM users. It's a cold solder joint at the antenna input of the receiver. If it's out ...

...antenna and still get the same problem. The problem is a bad tuner. Very common problem in XM and Sirius tuners. New models do not have this issue, they are built by DEI and very reliable. You can ...

...antenna be bad? Is there a more powerful antenna available for the car? It is surely the antennae. I have had to replace mine a few times too. The thing is, where it bends, like near the plug ...

antenna itself it usually bad. See if you can borrow a buddy's antenna just to see if the "Antenna" warning goes away. It could be the antenna & its connector, could be the docking base (make sure

...antenna pin solder joint on your dock connector is bad. I've seen this problem a lot (I buy returned sirius radios, fix them, and resell them). The antenna connector is on the right of the dock ...

...bad base unit and do they wear out over time. [email protected] You need to resolder your antenna port on the dock connector. It's a really easy repair, all you need is a fine tip soldering iron. The ...

...bad connection between radio and antenna. You could try to wiggle the antenna jack in the radio and see if that works. Could have a short in the antenna wire. Try different antenna if you have one. ...

antenna really is bad and/or not plugged in tight BEFORE you turn it on, or the docking unit you have it in has a bad connection to the radio and/or antenna connector. If you swap-out the base/dock or