...rest of the weekend. Got in the truck this morning warm up the truck b/c it was cold. Went up the street and l had no power and the engine didn't sound right. So I stopped and then the truck sounded ...
...rest you can eye, in the pulley on the pump just find a small deep socket works great. But make sure not to turn the motor over by hand or starter (remove the battier cable) you can move the crank on ...
rest of the way in when the oil pump drive aligns with the distributor. Now crank the engine around again and verify that the rotor is in the right place when the crank comes up on TDC compression. If
...rest should turn also. If something is stuck between a wheel and the case it chould prevent turning. A couple of other things could cause this problem. If the jet from the water supply is plugged or ...
...pump and o-ring in place as you secure it with the new bolts. Tighten them with a torque wrench to 105 inch pounds torque in any order. Step 3 Install the timing belt and wires, using the grease ...
Question about 1hp Power Flo Matrix Above Ground Pool Pump # Sp1592
...adjust "point gap" but can't find any posts on what the gap should be. Can anyone help me? The "points" you are talking about sound like the contacts. These are closed for starting and open when the ...
...rest of the engine; This will save you some labor and hardship later on so that you do not have to reconnect the actuator cable. 4. Use your hands to disconnect the electrical connection tab that ...
...worn parts though...it only buys you some time) Conditioners are never a fix if you get it repaired before you do damage to the rest of transmission you can just replace the pump and adjust the ...
...pump and o-ring in place as you secure it with the new bolts. Tighten them with a torque wrench to 105 inch pounds torque in any order. 11 Install the timing belt and wires, using the grease pencil ...
...pump sat.7Set the new bolts carefully into the holes in any order. Many 5.7 engines use two rounds of tightening, first with 11 foot pounds of torque and then with 22 foot pounds of torque. Reconnect ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions