...GMC Jimmy - Wheel bearings My 2001 GMC Jimmy has a grinding sound when traveling which I thought were my brakes. I found that my brakes were fine so I'm thinking its my bearings. I would like to know ...
want to know what the torque specs are for the idler arm, pitman arm and bearing hub and tie rods? for a 1998 gmc envoy 4x4 automatic 2000 gmc jimmy front cv axle nut (36 mm) torque ratings?
...GMC Jimmy SLS Right rear wheel wobbles as well as there is a rumbling sound. Wheel can be lifted up and down but not shifted manually from side to side. No shimming felt in sterring wheel.What cuold ...
...99 gmc jimmy Dear Jimmy, This repair is an intrusive repair if you have never done it.A chilton's manual can be purchased at your local auto parts store for $20 for your vehicle. Jack up the rear of ...
...99 GMC Jimmy with the 4 wheel drive. I I have a 99 GMC Jimmy with the 4 wheel drive. I don't have any indicator lights coming on in the dash switch. I changed the 4 wheel drive switch, witch is a 4 ...
Need torque spec for the 36 mm wheel bearing bolt on a 96 jimmy 130 ftlbs Source: Mitchell1 OD
GMC Jimmy 4WD. I believe the wheel bearing is bad. Can I change it myself? Use a slide hammer, bearing puller and adapter to remove the old axle bearing. special tools are required if the bearings are
A CRUSH SLEEVE ON A 2000 GMC JIMMY There is no spec for that. the sleeve must be compressed until you have the correct pinion bearing preload. The pinion must take 3-5 inch pounds of torque to spin it
what is the torque setting on a gmc jimmy 1999 front wheel hub 36mm nut. the torque for the outter axle nut at the wheel for a 1998 gmc jimmy is 103 ft lbs. hope this helps.
...gmc jimmy 4 wheel drive has excessive play in the drivers front tire when jacked up and shimmied. does that mean the wheel bearings are going out or is that drive shaft to that tire going bad? most ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions