Questions & Answers for: Buick Park Avenue 2 8 tps replace

no acceleration in drive but lots in reverse Hi! We have a 1992 Buick Park Ave. We've replaced the TPS because the code said it needed to be replaced. We had no acceleration before we put the TPS in ...

...22 on code scanner/replaced throttle position sensor/dont know which relay is for fuel cutoff 22TPS voltage was under 0.2 volts for 4 seconds when the ignition was on What is wrong with car? The ...

...replace my tps First by the part. This way you will know what it looks like. Find air filter housing. Follow up towards motor. You should see your throttle cable. Look closely you should see tps. You ...

I have a 1991 buick park ave and it idles high when in park and when I'm driving Try replacing your throttle position sensora(TPS). Had the same problem with my 93 park avenue.

...replace my iac valve twice a year every year! the computer always codes for the tps sensor, even though i know its fine and has also been replaced 3 times in 5 years. do you have a permanent solution ...

I have a 94 Buick park ave. I replaced icm, ecm, tps, map sensor, cam position sensor, and crank position sensor. Starter tested good but not getting a spark. What can it be Have you tried testing the

1992 Buick Park Ave. Ultra TPS problem Say techs..of older iron...1992 Buick Park ave. Ultra 3800 supercharged. got a code 21..replaced tps..set up closed throttle reading @ .38 of a volt. cant get ...

replace ECM car dies when warm check idle air control valve ok let me know or tps sensor

...TPS. Is that normal? Which are circuits A&B? I there a voltage regulator inside PCM? If so, can it be the problem? Can it be replaced? to fix problems with the PCM replace with a known good unit and ...