Questions & Answers for: 2005 rm 250 cylinder head

need fuel mixture for 2005 rm 250 what is the fuel mixture of 2005 rm 250 my bike runs best 40:1 but you can run it 32;1

...jug I have a 93 RM 125. what years can I use the cylinder off of? Also can I use a RM 250 cylinder? If so what years? No! you cant use 250 cylinder on 125. i think 93-96 have the same ...

1986 rm 250 water in oil (1986 rm 250) how do I troubleshoot water in oil? Is it the head gasket or wather pump gasket, bike still has lots of power. Its the head gasket ,you will have to replace it.

the proper torque thank you just put in rm 250 no category for atv The 8mm head bolts are torqued at 19 - 21 ft/lbs. any smaller 6mm bolts are torqued to only 6 ft/lbs like those on the lower cylinder

...the head, cilinder, reed cage and spark plug torque specs for a 1982 rm 250 you can call the Suzuki dealer for the specs and/or buy a tech manual for that bike. (and work on your spelling,

i need the torque specs on a 2000 rm 250 for the case cylinder and head also i forgot to add pul the gasket and head in evenly

...rm 250 2 stroke that died on me and now locked up. I have a 2003 rm 250 2 stroke that died on me and will not kick. It is locked about half way down in the kick. Can you advise me on what to check ...

...cylinder head torque on rgv 250 I have a vj22. When retightening cyl head bolts, I go to 21ft/lb then run the engine up to warm and retorque to 24 ft/lb. NB. I did use brand new studs though. Hope ...

2005 FXDLI need to remove bolts that hold the exhaust to engine ports Are they BOLTS, or nutted STUDS? If bolts, put a wrench to them! IF you mean how to remove the studs AFTER the exhaust is removed,

...2005 Yamaha Bruin 250 quad the side of my cylinder is starting to leak out oil on the outside. How can I fix this??? Should I re-torque the cylinder head??? You will need to replace the head gasket. ...