Question about 2004 Canyon
...blower motor works on high. intermittent on other speeds. The blower motor works on speed 4 when the dial is set on 4. However, on speeds 1,2,3 the blower works intermitently. The motor woks on speed ...
...works on high air cond. only works on high ALL YOU NEED TO DO IS REPLACE THE BLOWER MOTOR SPEED DROPPING RESISTOR, IT IS NEXT TO THE BLOWER HELD INTO THE AIR DUCT WITH TWO SCREWS. PLEASE RATE
The fan will work only at position 4 (maximum), is it the control ? its the resistor. its located down to the left of the blower motor, 4 wires.
AC switch only work on high the blower motor resistor went bad its located near the blower motor under the pass. side of the dash
...2005 GMC Canyons blower motor works only when the switch is placed on the highest position. Is it the switch, or the blower motor, or is there something that I am not thinking of? I believe your ...
...gmc 2005 canyon Replace the blower motor resister,it is mounted right next to the blower motor,it has a lug with about 7 wires on it.Just unplug it and remove two screws to remove the resister.This ...
...the check resistance or continuity on the resistor, if the no 2 is blown then the blower motor is probably drawing too much juice and blowing the resistor, which blew the first resistor ...
...truck has 41,000 miles Bad blower motor resistor normally located near the blower motor under the dash on the passenger side. Sometimes they are on the firewall under the hood on the passenger
heater fan only works on high This is caused by a defective blower motor speed control resistor, the resisitor is located next to the blower motor.
canyon no voltage at heater resistor heater not working at all no voltage at heater resistor with key on or off The resistor provides the ground circuit for the blower motor. So you would need to have
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions