Questions & Answers for: 10 master slave cylinder

Question about 1998 S-10 Pickup

1 Answer

...10 w/ 2.2 engine. The clutch pedal seems very mushy and won't disengage the clutch. There are 89600 miles on the truck. What can I do? make sure fluid is full... then pump the pedal with it NOT ...

Ad

...master and slave unit. Though for the moment this is more expensive, unless you have a perfect master cylinder, the new slave cylinder will destroy it in a hurry. It is cheaper to buy them together ...

Ad

...10. I have not started or drove this vehicle for a few months. I go to start it today and the clutch goes all the way to the floor with no resistance. Please help? Your S10 has a clutch master ...

Question about 1998 S-10 Pickup

2 Answers

a failed clutch hydraulic cylinder, most likely the slave cylinder down on the transmission, but since it is always recommended that both master and slave be replaced at the same time it makes no diff

...slave cylinder. Does that mean clutch master cylinder is bad? Got one from parts store but can't figure out how to take the clutch safty switch off to change it. Any ideas? Probably not. Bleeding ...

...10 2002 the clutch pedal sometimes goes all the way down and its hard to shift but then it goes back to normal like if nothing was wrong with the clutch . is there an adjustment i can make on it. ...

Question about 1994 S-10

1 Answer

...master/slave cylinder. Take a look where the slave cylinder goes into the transmission and have someone push and release the clutch. You'll be looking for the slave cylinder to move about one inch in ...

Question about 1997 S-10 Pickup

1 Answer

slave/master cylinder on 1989chevy s10 pickup? Bleeding the slave cylinder is done just like bleeding your brake system.Just be sure that you keep enough fluid in the master cylinder so that you don't

Question about 1993 Civic 4 Door

2 Answers

...10 months,go check your clutch master cylinder's fluid,if out,then slave cylinder is bad and should show signs of leakage.Another thing it could be if slave cylinder is good,then check the clutch ...

...10 and 11). (8) Remove clip securing clutch master cylinder push rod to pedal and slide push rod off pedal pin. (9) Disconnect clutch pedal position switch wires. (10) If pedal pin is equipped with ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...