Wall controller for ducted airwell can not get a new one anywere can you help.

Hello Heather
Good to see you again. The outlet on the back of the dryer is 4" and the wall duct has a 4" tail. The ducting flexible hose made to fit on the outside of both. You fix with large hose clamps. It sound like you are trying to put the dryer into the wall duct? That is not the right way. You have to have hose even if it is 10" worth, that has 4" inside diameter for both the dryer and the wall duct. The new magnetic connector make thing very easy.

The parts and the videos are in the link

https://www.google.com/search?q=DRYER+WALL+DUCT

..

make a communication to the manager of airwell and state that the unit is malfunctioning and you want technical assistance to get it to operate as designed

maybe the button for turn on is blocked

FROM THE AIRWELL RC-4 REMOTE CONTROL MANUAL

NOTE THE COMMENT ABOUT THE RESET AND THE SIMULTANEOUS SELECTION OF THE + - SET and CLEAR BUTTONS to effect a reset after replacingg batteries

HOW TO INSTALL BATTERIES Remove the lid in the rear part of the remote control unit.
Insert two AAA alkaline batteries of 1,5 V-DC. Make sure the batteries point in the direction marked in the battery compartment.
The batteries last about six months. Depending on how much you use the remote control unit. Remove the batteries if you do not use the remote control unit for more than one month. Press the +, -, SET and CLEAR buttons together after batteries replacement.
(This operation allows you to reset correctly all the programs. The remote control unit is to be set up again).Replace the batteries when the remote control unit lamp fails to light, or when the air conditioner does not receive the remote control unit signals.
The batteries of the remote control contain polluted substances exhausted batteries must be disposed according to the laws in force.

https://www.google.com.au/url?sa=t&rct=j&q=&esrc=s&source=web&cd=6&ved=0ahUKEwi_8IKByO3UAhVDVbwKHQB1B5AQFghUMAU&url=http%3A%2F%2Ftrade.jng.com.au%2Fhome%2Ffile%2F9031&usg=AFQjCNGiMLYsIf_M8G3-H0Ccni6xhE_0Ig&cad=rja

Hi

The old Airwell units were filled with R22, the use of R22 is now forbidden, however there are drop in refrigerants that can be used, even with mineral oil compressors, the most common is R417A

You need to contact your local experienced and helpful tech to recharge this.

Regards
Gordon

Henry, unfortunately Fedders as you knew them is now out of business, A company by the name or Airwell bought parts and manufacturing and it's now call Airwell-Fedders. You particular model is no longer available. However, if you contact Airwell-Fedders Customer Service 866-829-2440 or email them [email protected] they should be able to help you with the manual.

Good luck. I hope this helped you.

Check the unit that's located outside .You need to open it to get to the control board ,there you will see a couple of buss fuses. Check to see if fuses are fine. Do this with the power OFF on disconnect

Comms Error, check your wiring, remove external pumps. Split/Multi - check volts from terminal N to 3 = 0 - 65 Vdc, Multi V - 4 Vdc terminals 3 and 4

I am sorry if ask wha may seem like a few silly questions, but I need some clarification to assist you better.

-Is this a Residential AC Unit?
-If it is a residential AC unit, where is the thermostat located for this unit?
-Do you know if there is a wall mounted thermistor located on the wall in another room or in the room it cools?

I ask these questions, because generally if the fan coil is mounted in the ductwork, then there isn't always a way of controlling it remotely. Generally, it's controlled by hard-wired thermostat.
If you know it was controlled remotely, then you will need to go the website for the Airwell Fan coil and do a search on programming the remote. I'm sorry there is no short cut for this, you will need to obtain the code from Airwell.

Hope this helped... :D

If its for the unit pictured go to http://service.airwell.com.au/airwellsanyoparts/Website%202007%20update/airwell/XV26RCA/ and click on operation instructions.doc. Even though this is an airwell manual, they both use the same control.
Hope this helps
Mat