Notice on dryer, a problem has been detected, call for repair. This dryer is forever doing this. Is there a way to try to reset the dryer? I just had it worked on about 8 months ago, put in a new computer console. I did check the venting, as this was a problem at one time, does not seem to be any lint.

you shud be able to purchase a replacement here>>www.discountbargainprices.com

I just want to put this information in the Internet because I found nothing but an accurate and incomplete information. The Bosch 300 series electric dryer absolutely, positively, does have a reset switch. To access it you have to take the entire back plate off the dryer. There are like 30 torques screws. Takes forever. When viewing the back of the dryer down on the lower right there is a silver box shaped thing that is your heating element. Next to it is a red button. While googling I've found a dialogue between a repair man and a customer and the repairman said he looked at the schematic I did not have a reset switch. That information is wrong

Hello & Welcome to FixYa
If you have already cleaned the vent then the problem is with the Thermal fuse. When the thermal fuse goes bad it cannot be reset and replacing it is recommended repair. It is located on the blower wheel housing inside the rear panel to the exhaust duct. You can test it for continuity before replacing.Please get back to me if you have any other questions.
Kevin

Hello & Welcome to FixYa

If you have already tried cleaning the vent then the problem is with the Thermal fuse. When the thermal fuse goes bad it cannot be reset and replacing it is recommended repair.It is located on the blower wheel housing inside the rear panel to the exhaust duct. You can test the fuse for continuity before replacing, if the fuse is fine then please get back to me if you have any other questions.

Kevin

so it is drying clothes but is taking forever:

http://www.applianceaid.com/dryertip.html

http://www.partselect.com/dryer+wont-dry-clothes+repair.htm

so the dryer is not heating:

http://www.partselect.com/dryer+dryer-wont-heat+repair.htm

these should fix the problem Good Luck Tim

yes,the moisture sensor bars inside the unit can be replaced,you need to tear down part of the machine to do so,to further assist you,a model/serial# would help

I think it's dead, You might want to do a hard reset on it or wait for the battery to drain. I had a color version of this and it was forever freezing. If removing and then reconnecting the battery does not help then it might have worse issues. If all else fails I can take a shot at repairing it, my e-mail is [email protected]

You may want to try to reset the breaker.
I have a similar prob with my dryer. Something with the unit messes with the current enought to drop voltage enough to stop the heater but not the motor and it does not completely trip the breaker.
Cycle the breaker off, wait a minute and reset the breaker. That should work.
If not, it is probably the heating element.
Hope this helps and saves you money from (hopefully) unnecessary repairs.

If so, please rate me.
Thanks,
Matt

chould be a fuse inside dryer its oblong white ck it but unplug dryer first

DW, Press the power key to turn the washer on. If the washer is on and the Home screen is displayed, press help. If the home screen is not displayed press home then help. Then press my cycles and back together for 3 seconds. The control will display any recorded errors. A more icon will appear in the display if more than one error was recorded. Press the more icon to list any additional errors. Use the back keypad to scroll through them. Make note of all errors and post back. We'll try to help you with the problem. Catriver