Hi i need to add an callder id card to my existing tes 824 system. after i add the card physically to the 824. is there any programming changes required. If yes please explain

Yes, the Panasonic KX-T7667 phone and the Panasonic KX-TES824 PBX are compatible.
The KX-TES824 should be able to accommodate different handsets because it is made to work with a variety of Panasonic phones, including the KX-T7667 model.

You must connect the KX-T7667 phone to an available extension port on the PBX and configure it with the proper parameters using the PBX programming software or a web interface in order to add the phone to your current PBX system.

It's vital to keep in mind that the KX-T7667 is a proprietary phone made just for Panasonic PBX systems and might not work with other phone systems or third-party hardware.

It depends what telephone system the KX-T7730 is connected to. You should have a Panasonic box that says 'KX-TA624', 'KX-TEA308, 'KX-TES824' or similar somewhere.
Depending which Telephone System you have, it may just need programming or it may need an additional card (circuit board) installing. Panasonic KX TEA TES Telephone Systems Tiny Telecom

Try the parts department for your device at Panasonic . Com. support and parts.

Since that's done from SYSTEM program 000, it seems likely that you 1. Aren't using extension 101 and 2. Didn't log into the system for programming


Try it again.

Carl

This answers eaier in reverse order.

3. You find the drivers for the MC for your operating system. Our Pana dealer website has them, so I'd contact Panasonic for a solution.

2. The system needs programming. System programs 407-409 controls incoming ringing.

1. Did you install a 82493 CID card and programming?

Carl

To make your life easy, I have found the manual, it can be accessed here.

By programming. If the Auto Attendant is the DISA card, you can tell it to listen for the FAX tone and transfer it to the fax extension, or, you can program the 3rd number to ring only the fax extension and no others. Both require programming in the system cabinet.

Carl

go to your dealer and change the expansion card you purchase.

No. At the very minimum, you need to go to program 400 (3.3 in the U.S. Maintenance Console) and turn on the lines. Access may have to be enabled from each extension for both outward and ringing programming might have to be added.

Carl

CID on a 7730 reqoires 3 things, CID service from the phone company, programming on the sytsem, and a CALLER ID CARD. The card can only be added to TA-624/824, TAW-848, TD-816/1232, and TDA/TDE/NCP sytsems and has a part number ending in 93.

If it never worked from "day 1", then I'm guessing you either didn't order the card, or you forgot to inform your installer that you wanted CID turned on. Only the 50g and TA-824 models came with CID in the U.S.

Carl